2/2/2024 0 Comments Flexiglass canopy side windows![]() ![]() Remove the cover from over the latch on the right hand side of the rear window, remove the strut from the window bracket, remove the screw holding the latch to the cover and then undo the 2 nuts holding the latch to the window, take out the 2 bolts and insert the right hand window bracket on top of the rubber.The bracket can also be bent up or down to ensure the actuator pin engages with the pin when locked and clears the bracket when unlocked. This can be done by using a file to make the hole larger. Note: The hole in the bracket may have to be enlarged to ensure that the pin moves freely with the window handle in the open or closed position.Secure actuator to window frame using the 2 of the 8g x 12 screws. Now push the pin of the actuator fully down to make sure that the top of the pin clears the bracket so the window can be opened. Where the bracket is now installed place an actuator on the inside of the window frame under the bracket with the actuator pin extended upwards and line up the pin to the center of the hole in the bracket and the shoulder on the pin to the underside of the bracket.Using the pop rivets supplied install the bracket onto the window frame. Drill two holes through the bracket and into the window frame with a 3.5mm pop rivet drill. Select location for side window bracket (close to handle but leave enough room so as not to interfere with movement of the handle, and making allowance for the protection bracket to be installed). Installation:(Note if you are unsure of these steps please refer to the picture gallery at – most steps are shown)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |